TECH SUPPORT

FREQUENTLY ASKED QUESTIONS - CURTIS CONTROLS

Curtis Control Codes
     Question: I'm getting a code when troubleshooting my vehicle with a Curtis Control and I don't know what it means. Answer

Curtis 1204 Motor Controls
     Question: I've installed a replacement motor controller, why does my cart just take off? Answer

Curtis 1204 Motor Controls
     Question: My cart does not move when depressing the throttle. Answer

Curtis 1204-410/411/412 For Club Car
     Question: Can I replace my 1204-410 Control with a Curtis 1204-411 or 412? Answer

Curtis 1204-410/411/412 For Club Car
     Question: Can I replace my 1204-411 or 412 with a Curtis 1204-410? Answer

Curtis 1204 or 1205 Motor Controls
     Question: I have forward direction but no reverse (or vice versa). Answer

Curtis 1206-03 and 1206-04 For EZ-GO
     Question: Can I use a Curtis 1206-4 (4 Power Bars) in place of a 1206-03 (3 Power Bars)? Answer

Curtis 1206-03 and 1206-04 For EZ-GO
     Question: Can I use a Curtis 1206-3 (3 Power Bars) in place of a 1206-04 (4 Power Bars)? Answer

Curtis 1214's, 1215's, 1244's, 1207's
     Question: Why am I getting a throttle fault or high pedal disable fault, I checked my accelerator, it seems to be fine? Answer

Curtis 1243C-4376 For Hyster or Yale Vehicle
     Question: I installed a 1243C-4376 Curtis Control into a dual motor Hyster/Yale vehicle. I am getting an error displayed
      on the dash, TrcTMO or Comm Error 1243. Answer

Curtis 1264 ITS Accelerator Supply Voltage
     Question: What is the ITS Supply Voltage from Pin 13 to the ITS Accelerator for Curtis 1264-5407? Answer

Curtis 1264 Motor Controls
     Question: I've installed a replacement motor controller and I'm getting Code 5,3 or 5,2. Answer

Curtis 1264 For EZ-GO
     Question: I have forward but no reverse or vise versa. Answer

Curtis 1297 Motor Controls
     Question: I'm getting NO HANDSET function when connected. Answer

Multi Comm Tiller Card
    Question: I just purchased a Multi Comm Tiller Control Card for my Nacco vehicle. When I go into the Teach mode to     calibrate my Handle I get a “0” on the display instead of a centered Dash. Answer